Dentinal tubule occlusion with lanthanum fluoride and powdered apatite glass ceramics in vitro.
(1/97)
To simulate hypersensitive dentin, the smear layer and dentinal plugs of bovine root dentin specimens were removed by immersion in 10% phosphoric acid, polishing with hydroxyapatite particles, and ultrasonic cleansing. The fluoride-tannic acid-lanthanum-apatite (FTLA) group was treated with acidulated phosphate fluoride (APF) containing tannic acid followed by rubbing with a paste of lanthanum chloride (LaCl3) and powdered apatite glass ceramics. The treated specimens were immersed in a remineralizing solution that mimics saliva for 6 weeks. The SEM observations revealed that the treated surfaces of the FTLA group were completely covered with fine spherical compounds and the dentinal tubules were occluded with plugs to a depth of about 3 microns. Fluoride and lanthanum were detected to a depth of over 20 microns by EPMA observation. After the remineralization, the surface of FTLA-treated specimen did not have any opened tubules and showed a remarkable increase in the number of fine spherical deposits in the dentinal tubules. These results suggest that the reaction products produced by sequential treatment with acidic fluoride and LaCl3 and powdered apatite glass ceramics are able to effectively occlude dentinal tubules. (+info)
Early bactericidal activity of paromomycin (aminosidine) in patients with smear-positive pulmonary tuberculosis.
(2/97)
The early bactericidal activity of the aminoglycoside paromomycin (aminosidine) in doses of 7.5 and 15 mg/kg of body weight was measured in 22 patients with previously untreated smear-positive pulmonary tuberculosis. The fall in log(10) CFU per milliliter of sputum per day during the first 2 days of treatment for 7 patients receiving a paromomycin dosage of 7.5 mg/kg/day was 0.066, with a standard deviation (SD) of 0.216 and confidence limits from -0.134 to 0.266, and that for 15 patients receiving 15 mg/kg/day was 0.0924, with an SD of 0.140 and confidence limits from 0.015 to 0.170. The difference between the mean and zero was not significant for the 7. 5-mg/kg dose group but was significant for the 15-mg/kg dose group (t = 2.55, P = 0.023). Since paromomycin has no cross-resistance with streptomycin and has no greater toxicity than other aminoglycosides, these results suggest that it has the potential to substitute for streptomycin in antituberculosis regimens and may be a particularly valuable addition to the drug armamentarium for the management of multidrug-resistant tuberculosis. (+info)
Effect of Er:YAG laser irradiation on acid resistance to bovine dentin in vitro.
(3/97)
Resin bond strength to Er:YAG laser irradiated dentin has been reported to be lower than that of unlased dentin. The reasons have been much discussed, but not clarified. One hypothetical cause has been discussed that lased dentin is acid resistant, therefore, the etching effect of acid conditions decreases. The purpose of this study was to evaluate the acid resistance of laser-irradiated dentin and compare it with the dissolved mineral of Er:YAG laser irradiated dentin and unlased dentin. This experiment was a pilot study to assess the etching effect of pre-conditioner for resin bonding to lased dentin. Bovine dentin was irradiated by Er:YAG laser and immersed in 0.1 M lactic buffer solution (pH 4.0). The dissolved Ca and P in the solution were then both measured. Dissolved Ca from lased dentin was not significantly different from that coming from unlased dentin (p > 0.05). The molar ratio of Ca/P did not differ significantly between lased and unlased dentin, either (p > 0.05). Under FE-SEM view before immersion, the dentin surface was covered with a smear layer in unlased dentin, but this layer was not clearly observed in lased dentin. These results suggested that the lased dentin had little or no resistance to lactic buffer solution. (+info)
A study of cavity preparation by Er:YAG laser. Effects on the marginal leakage of composite resin restoration.
(4/97)
The purpose of this study was to evaluate marginal leakage of composite resin restoration from cavities prepared by Er:YAG laser. The observation of the dentin surface after the application of laser irradiation was performed by LSM, the cutting surface showed a rough surface similar to scales, and exposed dentinal tubules were observed without striations or a smeared layer formation that were observed when using a rotary cutting device. Leakage tests revealed no significant differences in the marginal seal for both enamel and dentin between cavities prepared by Er:YAG laser irradiation and when using an air-turbine. In this study, the usefulness of cavity preparation by Er:YAG laser irradiation in composite resin restoration was suggested. (+info)
Morphologic analysis, by means of scanning electron microscopy, of the effect of Er: YAG laser on root surfaces submitted to scaling and root planing.
(5/97)
The purpose of this study was to morphologically evaluate, by means of scanning electron microscopy, the effects of Er:YAG laser on the treatment of root surfaces submitted to scaling and root planing with conventional periodontal instruments. Eighteen root surfaces (n = 18), which had been previously scaled and planed, were assigned to 3 groups (n = 6). The control Group (G1) received no further treatment; Group 2 (G2) was irradiated with Er:YAG laser (2.94 mum), with 47 mJ/10 Hz, in a focused mode with air/water spray during 15 s and with 0.57 J/cm of fluency per pulse; Group 3 (G 3) was irradiated with Er:YAG laser (2.94 mum), with 83 mJ/10 Hz, in a focused mode with air/water spray during 15 s and with 1.03 J/cm2 of fluency per pulse. We concluded that the parameters adopted for Group 3 removed the smear layer from the root surface, exposing the dentinal tubules. Although no fissures, cracks or carbonized areas were observed, an irregular surface was produced by Er:YAG laser irradiation. Thus, the biocompatibility of the irradiated root surface, within the periodontal healing process, must be assessed. (+info)
Effectiveness of EDTA and EDTA-T brushing on the removal of root surface smear layer.
(6/97)
The purpose of this study was to compare the removal of root surface smear layer following active application of EDTA gel and EDTA-T (texapon) gel in different concentrations (5%, 10%, 15%, 20% and 24%), using scanning electron microscopy. A total of 220 dentin blocks obtained from the root surfaces of extracted teeth were divided into 3 groups: Group I - (control) application of saline solution (n = 20); Group II - EDTA gel (pH 7.0) was applied in the following concentrations: 5%, 10%, 15%, 20% and 24% (n = 100); Group III - EDTA-T gel (pH 7.0) applied in the same concentrations described above (n = 100). The photomicrographs were evaluated by one calibrated examiner using a smear layer removal index and following statistical analysis (Kruskal-Wallis test). The results demonstrated that the specimens treated with EDTA and EDTA-T gel presented a better smear layer removal than the control group (p < 0.01); no statistically significant differences were observed between the EDTA and EDTA-T groups and between the concentrations tested (Mann-Whitney, p > 0.05). Within the limits of this study, it can be concluded that all treatment modalities effectively removed the smear layer from the root surface. The addition of texapon into the EDTA gel formulation did not increase its effectiveness. (+info)
Smear layer removal capacity of disinfectant solutions used with and without EDTA for the irrigation of canals: a SEM study.
(7/97)
The purpose of this study was to carry out a scanning electron microscopic (SEM) analysis of the cleaning qualities and smear layer removal from root canal walls, instrumented and irrigated with 2.5% NaOCl, 2.0% chlorhexidine and saline solutions. Fifty extracted teeth were used in this study. All teeth were radiographed to determine the existence of a single canal. The crowns were cut at the cervical limit and the root canals were instrumented with K-type files up to size 45. During root canal preparation, irrigations were made with the different solutions being evaluated: Group 1: 2.5% NaOCl (10 roots); Group 2: 2.5% NaOCl and 17% EDTA for 2 minute (10 roots); Group 3: 2.0% chlorhexidine (10 roots); Group 4: 2.0% chlorhexidine and 17% EDTA for 2 minutes (10 roots); Group 5: saline solution (5 roots); Group 6: saline solution and 17% EDTA for 2 minutes (5 roots). After instrumentation, the canals were irrigated with each one of the solutions and the roots were cut in the buccolingual direction for SEM analysis, at the cervical, middle and apical thirds, to ascertain the presence or absence of smear layer and debris. SEM analysis was performed by three calibrated examiners and scores were submitted to Kruskal-Wallis test at the significance level of p = 5%. Results showed that the use of 17% EDTA decreased the smear layer significantly (p < 0.05) for all evaluated solutions in all thirds. When EDTA was not used, a significantly higher quantity of smear layer on the apical third was observed only in the NaOCl groups. The use of 17% EDTA was significant for debris removal except for the chlorhexidine groups. The following conclusion could be drawn: the use of 17% EDTA was necessary to enhance cleanness of the root canals. (+info)
Influence of natural fruit juices in removing the smear layer from root surfaces--an in vitro study.
(8/97)
Certain elements of a patient's diet may be associated with dentin hypersensitivity. The intent of this study was to evaluate the degree of removal of the smear layer from dentin surfaces by various fruit juices. A smear layer was created on extracted human teeth by manual scaling. The roots were reduced and distributed into 8 experimental groups. Distilled water was the negative control. The juices were applied by 2 methods: topical application and topical application with friction. Specimens were photomicrographed and graded according to an index of smear layer removal. With topical application, all but 2 of the tested substances resulted in significantly greater removal of the smear layer and opening of dentinal tubules than was the case with the negative control (p = 0.05); the exceptions were Gala apple and Italian grape juices, which were no different from the control. For the active application (with friction), most substances removed more smear layer than the control (p < 0.05); Gala apple, Italian grape and orange juices were similar to the control. For each of the tested substances, removal of the smear layer did not differ with the method of application (topical vs. friction; p > 0.05). It is concluded that natural fruit juices can remove the smear layer from dentin surfaces, and the efficacy of this removal varies with the type of juice. (+info)