Cell surface analysis techniques: What do cell preparation protocols do to cell surface properties?
(73/8297)
Cell surface analysis often requires manipulation of cells prior to examination. The most commonly employed procedures are centrifugation at different speeds, changes of media during washing or final resuspension, desiccation (either air drying for contact angle measurements or freeze-drying for sensitive spectroscopic analysis, such as X-ray photoelectron spectroscopy), and contact with hydrocarbon (hydrophobicity assays). The effects of these procedures on electrophoretic mobility, adhesion to solid substrata, affinity to a number of Sepharose columns, structural integrity, and cell viability were systematically investigated for a range of model organisms, including carbon- and nitrogen-limited Psychrobacter sp. strain SW8 (glycocalyx-bearing cells), Escherichia coli (gram-negative cells without a glycocalyx), and Staphylococcus epidermidis (gram-positive cells without a glycocalyx). All of the cell manipulation procedures severely modified the physicochemical properties of cells, but with each procedure some organisms were more susceptible than others. Considerable disruption of cell surfaces occurred when organisms were placed in contact with a hydrocarbon (hexadecane). The majority of cells became nonculturable after air drying and freeze-drying. Centrifugation at a high speed (15,000 x g) modified many cell surface parameters significantly, although cell viability was considerably affected only in E. coli. The type of washing or resuspension medium had a strong influence on the values of cell surface parameters, particularly when high-salt solutions were compared with low-salt buffers. The values for parameters obtained with different methods that allegedly measure similar cell surface properties did not correlate for most cells. These results demonstrate that the methods used to prepare cells for cell surface analysis need to be critically investigated for each microorganism so that the final results obtained reflect the nature of the in situ microbial cell surface as closely as possible. There is an urgent need for new, reliable, nondestructive, minimally manipulative cell surface analysis techniques that can be used in situ. (+info)
Physiological adaptations involved in alkane assimilation at a low temperature by Rhodococcus sp. strain Q15.
(74/8297)
We examined physiological adaptations which allow the psychrotroph Rhodococcus sp. strain Q15 to assimilate alkanes at a low temperature (alkanes are contaminants which are generally insoluble and/or solid at low temperatures). During growth at 5 degrees C on hexadecane or diesel fuel, strain Q15 produced a cell surface-associated biosurfactant(s) and, compared to glucose-acetate-grown cells, exhibited increased cell surface hydrophobicity. A transmission electron microscopy examination of strain Q15 grown at 5 degrees C revealed the presence of intracellular electron-transparent inclusions and flocs of cells connected by an extracellular polymeric substance (EPS) when cells were grown on a hydrocarbon and morphological differences between the EPS of glucose-acetate-grown and diesel fuel-grown cells. A lectin binding analysis performed by using confocal scanning laser microscopy (CSLM) showed that the EPS contained a complex mixture of glycoconjugates, depending on both the growth temperature and the carbon source. Two glycoconjugates [beta-D-Gal-(1-3)-D-GlcNAc and alpha-L-fucose] were detected only on the surfaces of cells grown on diesel fuel at 5 degrees C. Using scanning electron microscopy, we observed strain Q15 cells on the surfaces of octacosane crystals, and using CSLM, we observed strain Q15 cells covering the surfaces of diesel fuel microdroplets; these findings indicate that this organism assimilates both solid and liquid alkane substrates at a low temperature by adhering to the alkane phase. Membrane fatty acid analysis demonstrated that strain Q15 adapted to growth at a low temperature by decreasing the degree of saturation of membrane lipid fatty acids, but it did so to a lesser extent when it was grown on hydrocarbons at 5 degrees C; these findings suggest that strain Q15 modulates membrane fluidity in response to the counteracting influences of low temperature and hydrocarbon toxicity. (+info)
Isolation and characterization of a sulfate-reducing bacterium that anaerobically degrades alkanes.
(75/8297)
An alkane-degrading, sulfate-reducing bacterial strain, AK-01, was isolated from an estuarine sediment with a history of chronic petroleum contamination. The bacterium is a short, nonmotile, non-spore-forming, gram-negative rod. It is mesophilic and grows optimally at pH 6.9 to 7.0 and at an NaCl concentration of 1%. Formate, fatty acids (C4 to C16) and hydrogen were readily utilized as electron donors. Sulfate, sulfite, and thiosulfate were used as electron acceptors, but sulfur, nitrite, and nitrate were not. Phenotypic characterization and phylogenetic analysis based on 16S rRNA gene sequence indicate that AK-01 is most closely related to the genera Desulfosarcina, Desulfonema, and Desulfococcus in the delta subdivision of the class Proteobacteria. It is phenotypically and phylogenetically different from strains Hxd3 and TD3, two previously reported isolates of alkane-degrading, sulfate-reducing bacteria. The alkanes tested to support growth of AK-01 had chain lengths of C13 to C18. 1-Alkenes (C15 and C16) and 1-alkanols (C15 and C16) also supported growth. The doubling time for growth on hexadecane was 3 days, about four times longer than that for growth on hexadecanoate. Mineralization of hexadecane was indicated by the recovery of 14CO2 from cultures grown on [1-14C]hexadecane. Degradation of hexadecane was dependent on sulfate reduction. The stoichiometric ratio (as moles of sulfate reduced per mole of hexadecane degraded) was 10.6, which is very close to the theoretical ratio of 12.25, assuming a complete oxidation to CO2. Anaerobic alkane degradation by sulfate reducers may be a more widespread phenomenon than was previously thought. (+info)
Electrophoretic mobilities of Escherichia coli O157:H7 and wild-type Escherichia coli strains.
(76/8297)
The electrophoretic mobilities (EPMs) of a number of Escherichia coli O157:H7 and wild-type E. coli strains were measured. The effects of pH and ionic strength on the EPMs were investigated. The EPMs of E. coli O157:H7 strains differed from those of wild-type strains. As the suspension pH decreased, the EPMs of both types of strains increased. (+info)
Effect of gramicidin A on the dipole potential of phospholipid membranes.
(77/8297)
The effect of channel-forming peptide gramicidin A on the dipole potential of phospholipid monolayers and bilayers has been studied. Surface pressure and surface potential isotherms of monolayers have been measured with a Langmuir trough equipped with a Wilhelmy balance and a surface potential meter (Kelvin probe). Gramicidin has been shown to shift pressure-area isotherms of phospholipids and to reduce their monolayer surface potentials. Both effects increase with the increase in gramicidin concentration and depend on the kind of phosphatidylcholine used. Application of the dual-wavelength ratiometric fluorescence method using the potential-sensitive dye RH421 has revealed that the addition of gramicidin A to dipalmitoylphosphatidylcholine liposomes leads to a decrease in the fluorescence ratio of RH421. This is similar to the effect of phloretin, which is known to decrease the dipole potential. The comparison of the concentration dependences of the fluorescence ratio for gramicidin and phloretin shows that gramicidin is as potent as phloretin in modifying the membrane dipole potential. (+info)
Separation of submicron bioparticles by dielectrophoresis.
(78/8297)
Submicron particles such as latex spheres and viruses can be manipulated and characterized using dielectrophoresis. By the use of appropriate microelectrode arrays, particles can be trapped or moved between regions of high or low electric fields. The magnitude and direction of the dielectrophoretic force on the particle depends on its dielectric properties, so that a heterogeneous mixture of particles can be separated to produce a more homogeneous population. In this paper the controlled separation of submicron bioparticles is demonstrated. With electrode arrays fabricated using direct write electron beam lithography, it is shown that different types of submicron latex spheres can be spatially separated. The separation occurs as a result of differences in magnitude and/or direction of the dielectrophoretic force on different populations of particles. These differences arise mainly because the surface properties of submicron particles dominate their dielectrophoretic behavior. It is also demonstrated that tobacco mosaic virus and herpes simplex virus can be manipulated and spatially separated in a microelectrode array. (+info)
Protein adhesion force dynamics and single adhesion events.
(79/8297)
Using the manipulation force microscope, a novel atomic force microscope, the adhesion forces of bovine serum albumin, myoglobin, ferritin, and lysozyme proteins to glass and polystyrene substrates were characterized by following the force necessary to displace an adsorbed protein-covered microsphere over several orders of magnitude in time. This force was consistent with a power law with exponent a = 0.37 +/- 0.03 on polystyrene, indicating that there is no typical time scale for adhesion on this substrate. On glass, the rate of adhesion depended strongly on protein charge. Forces corresponding to single protein adhesion events were identified. The typical rupture force of a single lysozyme, ferritin, bovine serum albumin, and myoglobin protein adhering to glass was estimated to be 90 +/- 10 pN, 115 +/- 13 pN, 277 +/- 44 pN, and 277 +/- 44 pN, respectively, using a model of the experimental system. These forces, as well as the force amplitudes on hydrophobic polystyrene, correlate with protein stiffness. (+info)
Delta psi stimulates membrane translocation of the C-terminal part of a signal sequence.
(80/8297)
For several proteins in Escherichia coli it has been shown that the protonmotive force (pmf) dependence of translocation can be varied with the signal sequence composition, suggesting an effect of the pmf on the signal sequence. To test this possibility, we analyzed the effect of the membrane potential on translocation of the signal sequence. For this purpose, a precursor peptide was used (SP+7), corresponding to the signal sequence of PhoE with the first seven amino acids of the mature part that can be processed by purified leader peptidase. Translocation was studied in pure lipid vesicles containing leader peptidase, with its active site inside the vesicles. In the presence of a positive inside Delta psi, the amount of processing of SP+7 was significantly higher than without a Delta psi, indicating that the translocation of the cleavage region is stimulated by Delta psi. Replacement of the helix-breaking glycine residue at position -10 in the signal sequence for a leucine abolished the effect of Delta psi on the translocation of the cleavage region. It is concluded that Delta psi directly acts on the wild type signal sequence by stimulating the translocation of its C terminus. We propose that Delta psi acts on the signal sequence by stretching it into a transmembrane orientation. (+info)