Identification of dermal exposure pathways in the rubber manufacturing industry. (33/298)

Current existing dermal exposure assessment strategies are predominantly based on regulatory protocols. In order to develop effective and efficient strategies more data driven approaches are needed. In a recently developed conceptual model for dermal exposure, compartments, barriers and mass transport processes relevant for dermal exposure were described. We systematically applied this conceptual model to the rubber manufacturing industry to assess dermal exposure to cyclohexane soluble matter (CSM) and used quantitative data to design an exposure assessment strategy. Identification of the spatial distribution of the dermal contamination showed high CSM surface concentrations for the upper body. Moreover, because of the high correlation between dermal exposure at the wrist and calculated total body exposure (r=0.89, P<0.01) an exposure assessment strategy based on only one pad sampler was employed to estimate CSM surface concentrations in the skin contaminant layer. Qualitative and quantitative evaluation of the relevant compartments and related mass transport processes demonstrated the importance of deposition of airborne contaminants and direct transfer of contaminants from sources and surfaces to the skin contaminant layer. Interestingly, the importance of the different exposure pathways varied considerably between production functions. The use of a model driven exposure assessment strategy in the rubber manufacturing industry revealed relevant skin regions, compartments and mass transport processes and enabled development of an effective and efficient strategy for dermal exposure assessment and hazard control in this particular occupational setting.  (+info)

Inhibitory effect of Pseudomonas aeruginosa on the phagocytic and killing activity of rabbit polymorphonuclear leukocytes: mechanisms of action of a polymorphonuclear leukocyte inhibitor. (34/298)

The polymorphonuclear leukocyte (PMN) inhibitor isolated from a strain of Pseudomonas aeruginosa which is resistant to the phagocytic and killing activities of rabbit PMN inhibited migration of PMN and engulfment of latex particles by PMN. In studies of the bactericidal metabolism of PMN, the PMN inhibitor did not inhibit the intracellular activity and extracellular release of lysosomal enzymes. However, the PMN inhibitor caused a decrease of Nitro Blue Tetrazolium reduction. The PMN inhibitor had a cytotoxic effect on PMN and inhibited [14C]tyrosine uptake in intact PMN inhibitor had no inhibitory effect on protein synthesis in cell extracts.  (+info)

Purification and identification of a growth-stimulating peptide for Bifidobacterium bifidum from natural rubber serum powder. (35/298)

Natural rubber serum powder, which is a by-product obtained in the production of latex rubber, has a strong growth-stimulating activity for Bifidobacterium bifidum JCM 1254. The retained fraction obtained by ultrafiltration (molecular weight cutoff 1000) showed a growth-stimulating activity in a dose-dependent manner on B12 assay medium with ammonium sulfate. One of the growth stimulators was purified from the retained fraction by acetone precipitation, solid-phase extraction with a hydrophobic pretreatment column, and multistage reversed-phase HPLC. An increase of 53-fold in the specific activity, and a recovery of 1.3% were obtained. The amino acid composition and N-terminal sequence analysis of this growth stimulator provided the structure of Ala-Thr-Pro-Glu-Lys-Glu-Glu-Pro-Thr-Ala. The molecular mass was 1075 by MALDI-TOF MS analysis. These results showed that this growth stimulator was a decapeptide with the sequence shown above. This is the first report that clarified the structure of an active peptide for the growth of Bifidobacterium.  (+info)

Enzymatic determination of serum urea on the surface of silicone-rubber pads. (36/298)

An enzymatic, fluorometric method is described for determination of serum urea on silicone-rubber pads. In this method, the reagents are lyophilized on the surface of the pads, NADH on one side and a mixture of urease, glutamate dehydrogenase, and alpha-ketoglutarate on the other. The rate of disappearance of NADH fluorescence at 460nm (excitation wavelength, 340 nm) is monitored and related to serum urea concentration. The calibration curve is linear to 250 mg of urea per liter. The method affords a rapid, simple, and inexpensive means for urea assay, the results of which correlate well with automatic diacetyl monoxime method (correlation coefficient, 0.998).  (+info)

A novel method of assessing the effectiveness of protective gloves--results from a pilot study. (37/298)

We have devised a novel method for evaluating the effectiveness of protective gloves and have undertaken a small study to assess this approach. Three types of glove were tested in a standardised simulation test with a permethrin-based pesticide. Prewashed cotton gloves were used to collect the samples. One was worn over the protective glove on one hand to measure the potential deposition of pesticide on the hands had the gloves not been worn. A second was placed under the protective glove on the opposite hand to measure the actual deposition of permethrin on the hands when the gloves were worn. This regime was reversed half way through each test in an attempt to prevent bias. Measurable inner glove contamination occurred on 25 out of 30 occasions. Geometric mean protection factors were calculated from the ratio of outer and inner sampling glove contamination, with average protection factors of 470, 200 and 96 being obtained for the two nitrile and PVC gloves, respectively. The PVC gloves were the least effective in preventing inner glove contamination, probably because the glove was thick and fairly inflexible, causing more pesticide to enter the glove around the cuff. Although the tasks were standardised, variability occurred due to worker behaviour and equipment failure. The spray pump failed on five occasions, resulting in higher levels of inner glove contamination and a geometric mean protection factor of 32. On the occasions when the pump worked correctly, the level of protection provided by the gloves rose dramatically with mean protection factors of 220 and 450 being obtained for workers categorised as "messy" and "tidy", respectively.  (+info)

Occurrence of coring in insulin vials and possibility of rubber piece contamination by self-injection. (38/298)

Coring is reported to occur because rubber pieces are shaved off from a rubber stopper when a needle is inserted into the rubber stopper of transfusion liquid formulation. We verified whether coring really occurs in insulin vials of self-injecting patients. We collected insulin cartridges from 30 hospitalized patients and used the primary injection (trial injection), the secondary injection and the cartridge remaining preparation as samples. We observed the rubber pieces using a microscope and measured the shape, number of pieces. The occurrence rate of coring was 73% for the primary injection, 47% for the secondary injection and 97% for the cartridge remaining preparation. The rubber pieces in the primary injection and the secondary injection which went through the needle are mostly in aggregate shape and the rubber pieces in the cartridge remaining preparation which did not go through the needle are mostly in needle-like shape. A number of small rubber pieces are found in both the primary injection and the secondary injection, indicating a high possibility that rubber pieces may be injected under subcutaneous tissue. The coring is considered to occur because needles are repeatedly inserted and rotated at the same spot. It is required to improve the structure to mount a needle to the pen-type injector in future. Coring is a very serious problem from the medical and pharmaceutical points of view. Further study should be made on the implication to latex allergy and lipodystrophy.  (+info)

An epidemiological study of occupational bladder tumours in the dye industry of Japan. (39/298)

This report studies 100 cases of occupational bladder cancer which were reported between 1949 and 1970 by large companies producing dye. It is estimated that in fact a great many more than 100 cases may have developed during the 56 years from 1914 to 1970, as this period corresponds with the beginning of dye production to the termination of benzidine and beta-naphthylamine manufacture in Japan. New cases of occupational bladder tumour should diminish significantly in the future in Japan on account of the prohibition of the production of beta-naphthylamine and benzidine. However, it is important to follow-up continuously workers who have been exposed to these amines. In Japan no cases of occupational bladder tumours from the rubber industry have been reported. It is emphasized that prospective epidemiological studies are required not only in the rubber industry but also in other industries where amines may constitute an occupational hazard.  (+info)

Adenovirus binds to rat brain microtubules in vitro. (40/298)

We have found by negative staining electron microscopy that when similar concentrations of adenovirus and reovirus (viruses of about the same diameter, 75 to 80 nm, and density, 1.34 to 1.36 g/cm3) were incubated with a carbon support film containing microtubules, 72% of adenovirus on the grid, but only 32% (equivalent to random association) of reovirus, were associated with microtubules. Similar concentrations of both larger and smaller particles, such as polystyrene latex spheres and coliphage f2, also exhibited a low degree of interaction, viz., 17 to 37%, with microtubules. Moreover, 90% of microtubule-associated adenovirus binds to within +/- 4 nm of the edge of microtubules, but lower fractions (again equivalent to a random association) of the other particles bind to the edge of the microtubules. The mechanism behind this phenomenon, which we denote as "edge binding," is presently obscure; however, it provides us with a second, albeit empirical, method to distinguish between the microtubular association of adenovirus and other particles. We found that edge binding of adenovirus also occurred when adenovirus was initially placed on the carbon support film and then incubated with microtubules and when adenovirus and microtubules were mixed prior to placement on the support. In contrast, reovirus or the other particles prepared by similar techniques exhibited a random amount of edge binding. The binding of adenovirus appears to involve the hexon capsomers of the virion since (i) high resolution electron micrographs showed that the edge of the virus was in contact with the edge of the microtubules, and (ii) adenovirions briefly treated with formamide to remove pentons and fibers bind as efficiently as intact virions. Core structures, which were obtained by further formamide degradation of the virion, do not associate with microtubules. These observations support the hypothesis of Dales and Chardonnet (1973) that the transport of adenovirions within infected cells is mediated by interaction with microtubules.  (+info)