Morphological evolution, ecological diversification and climate change in rodents. (33/219)

Among rodents, the lineage from Progonomys hispanicus to Stephanomys documents a case of increasing size and dental specialization during an approximately 9 Myr time-interval. On the contrary, some contemporaneous generalist lineages like Apodemus show a limited morphological evolution. Dental shape can be related to diet and can be used to assess the ecological changes along the lineages. Consequently, size and shape of the first upper molar were measured in order to quantify the patterns of morphological evolution along both lineages and compare them to environmental trends. Climatic changes do not have a direct influence on evolution, but they open new ecological opportunities by changing vegetation and allow the evolution of a specialist like Stephanomys. On the other hand, environmental changes are not dramatic enough to destroy the habitat of a long-term generalist like Apodemus. Hence, our results exemplify a case of an influence of climate on the evolution of specialist species, although a generalist species may persist without change.  (+info)

Anthropoid primates from the Oligocene of Pakistan (Bugti Hills): data on early anthropoid evolution and biogeography. (34/219)

Asian tarsiid and sivaladapid primates maintained relictual distributions in southern Asia long after the extirpation of their close Holarctic relatives near the Eocene-Oligocene boundary. We report here the discovery of amphipithecid and eosimiid primates from Oligocene coastal deposits in Pakistan that demonstrate that stem anthropoids also survived in southern Asia beyond the climatic deterioration that characterized the Eocene-Oligocene transition. These fossils provide data on temporal and paleobiogeographic aspects of early anthropoid evolution and significantly expand the record of stem anthropoid evolution in the Paleogene of South Asia.  (+info)

An approach to maintain orthodontic alignment of lower incisors without the use of retainers. (35/219)

The purpose of this investigation was to examine the long-term stability of orthodontic alignment of lower incisors without the use of retainers. The study sample comprised 56 patients treated according to a protocol that included over-correction of rotated teeth at an early stage of treatment and systematic enamel reduction (stripping) of the approximal surfaces in the mandibular anterior region, both during treatment and follow-up. Care was also taken to maintain dental arch form and to avoid lateral expansion of the lower dental arch and proclination of the incisors. Dental study casts were obtained pre-treatment, at the end of treatment, and 3 years post-treatment. Alignment of the mandibular incisors was recorded using Little's irregularity index. The inter-canine distance and the sum of the mesio-distal widths of the mandibular incisors and canines were also measured. The total amount of enamel removed from the approximal surfaces of the lower anterior teeth ranged from 0.3 to 5.0 mm (mean 1.9 mm). The mean increase in irregularity index score of 0.6 from post-treatment to 3 years follow-up indicated good stability. In 45 per cent of the patients the change in score during this period was less than 0.5, indicating that the treatment approach presented may be considered an alternative strategy to placement of lower retainers to safeguard the stability of alignment of mandibular incisors.  (+info)

Anterior tooth morphology and its effect on torque. (36/219)

This study was undertaken to determine the variation in crown-root angle (CRA) of the upper incisors and canines as well as the variation in their labial contour. In addition, the influence of the variability of the labial contour and of different bracket heights on torque was evaluated. Proximal radiographs were taken of 160 extracted maxillary teeth (81 incisors and 79 canines). They were digitized and analysed with Jasc Paint Shop Pro 7TM and Mathcad 2001 Professional. The incisal edge, the centre of the cemento-enamel junction (CEJ), and the root apex were digitized to define the crown and root long axis. For all teeth the CRA was measured. At several heights of the labial surface a tangent was determined, enabling measurement of the inclination of the labial surface. The CRA had great variability, ranging from 167 to 195 degrees for the canines (mean value 183 degrees) and from 171 to 195 degrees for the incisors (average 184 degrees). The mean inclinations of the labial surfaces for the incisors varied greatly. Between 4 and 4.5 mm from the incisal edge the standard deviations (SD) were the smallest and between 2 and 4.5 mm from the incisal edge the labial surface angle differed by approximately 10 degrees. For the canines the mean inclinations of the buccal surface also varied. This angle differed by around 10 degrees between 2 and 4.5 mm from the incisal edge, but the SD were much larger than for the incisors. It can be concluded that placement of a bracket on a tooth at varying heights, still within a clinically acceptable range, results in important differences in the amount of root torque.  (+info)

Clinical management of 3 mandibular incisors with 2 separate canals and foramina: case report. (37/219)

This case report describes the root canal treatment of 3 mandibular incisors, each with 2 separate canals and foramina, in 1 patient. The case demonstrates an unusual morphological configuration of the root canal system and supplements previous reports of the existence of such configurations in mandibular incisors.  (+info)

Space conditions and dental and occlusal features in patients with palatally impacted maxillary canines: an aetiological study. (38/219)

The aetiology of palatal canine impaction is unclear. The aim of this research was to investigate the occlusal features that could contribute to the aetiology of palatal maxillary canine impaction. The material consisted of the pre-treatment dental casts of 34 patients (27 female and seven male) with unilateral palatal canine impaction (impaction group). The average age of this group was 17.7 years (+/- 4.6). These were matched according to age, gender and type of malocclusion with a comparison group of pre-treatment dental casts from unaffected orthodontic patients. From the dental casts the following parameters were obtained: (1) dentoalveolar arch relationship, (2) missing or anomalous teeth, (3) the mesiodistal width of each maxillary tooth, (4) the upper arch perimeter, (5) the maxillary inter-premolar and inter-molar widths. The arch length-tooth size discrepancy was only calculated for subjects with no missing teeth. Palatal canine impaction occurred most frequently in subjects with a Class II division 2 malocclusion. There was an association between palatal canine impaction and anomalous lateral incisors (P = 0.01). The transverse arch dimension was significantly wider in the impaction group than in the comparison group (P < 0.01). There was no statistically significant difference in the mesiodistal width of maxillary teeth or in the arch length-tooth size discrepancy between the palatal canine impaction group and their matched comparisons (P > 0.05). These results suggest that the presence of an 'excess palatal width' and anomalous lateral incisor may contribute to the aetiology of palatal canine impaction.  (+info)

Hypodontia in orthodontically treated children. (39/219)

The frequency of hypodontia in orthodontically treated children, both male and female, and the association between tooth type, the upper or lower arch, the affected side and Angle's classification were studied using interviews, oral, study cast and panoramic radiographic examinations of 212 patients with a mean age of 12 years 7 months. A hypodontia frequency of 11.3 per cent was found for the total sample. This was higher than the incidence of hypodontia reported in other studies of orthodontically treated children. The most frequently missing teeth were the maxillary lateral incisors, and maxillary and mandibular second premolars. The missing teeth were more often absent on the right (54.2 per cent) than on the left (45.8 per cent) side, in both males and females. One tooth was absent in 29.2 per cent of patients, two in 58.5 per cent, but seldom three or more. Orthodontic space closure was the treatment of choice in 87.5 per cent of the subjects.  (+info)

Third molar influence on dental arch crowding. (40/219)

The aim of the present study was to measure the dental arches in order to assess the potential influence of third molars on lower incisor crowding. Changes in dental arch dimensions were assessed in 47 patients (36 females, 11 males) three years following either removal of the third molars or deciding to leave them in situ. A dental pantomogram (DPT) was taken at the start of the study and plaster study models were obtained at both the beginning and end of the observation period. The study models were used to measure crowding, and to prepare photocopies for linear measurements of the dental arch (length and width). Using the DPT, the ratio of retromolar space to the width of the crown of the third molar was calculated using the method originally described by Olive and Basford and later modified by Ganss (Ganss ratio). The results showed that the measurements of crowding and arch length and width had changed in 12 lower and two upper dental arches. The relationship between these results and the Ganss ratio was statistically significant. Calculation of the Ganss ratio may therefore assist investigations into the development of dental arch crowding and also help determine the indications for third molar removal.  (+info)