Size-selective sampling of oil mist in air and subjective symptoms among machine workers. (49/51)

Oil mists at an automobile factory were measured size-selectively. Furthermore, subjective symptoms were surveyed through the distribution of a questionnaire. The measured levels of respirable-size, 2-10 micrometer oil mists at 3 selected workshops ranged 0.04-0.09 mg/m3 for the lower exposed group (17 men), 0.10-0.18 mg/m3 for the higher exposed group (16 men) to water-insoluble oil, and 0.08-0.29 mg/m3 for the higher exposed group (19 men) to water-soluble oil. The higher the level of exposure to respirable-size particulates, the more workers complained of dissatisfaction with air quality. As to the subjective symptoms, the "yes" rate for "irritated nose" and "sneezing" showed significant differences among the unexposed, lower exposed, and higher exposed groups. Workers using water-soluble oil complained of "uncomfortable smell" more than those who used water-insoluble oil. The results of this study suggested that it is necessary to measure the levels of oil mists size-selectively.  (+info)

Variability in the skin exposure of machine operators exposed to cutting fluids. (50/51)

OBJECTIVE: This study describes a new technique for measuring skin exposure to cutting fluids and evaluates the variability of skin exposure among machine operators performing cyclic (repetitive) work. METHODS: The technique is based on video recording and subsequent analysis of the video tape by means of computer-synchronized video equipment. The time intervals at which the machine operator's hand was exposed to fluid were registered, and the total wet time of the skin was calculated by assuming different evaporation times for the fluid. The exposure of 12 operators with different work methods was analyzed in 6 different workshops, which included a range of machine types, from highly automated metal cutting machines (ie, actual cutting and chip removal machines) requiring operator supervision to conventional metal cutting machines, where the operator was required to maneuver the machine and manually exchange products. RESULTS: The relative wet time varied between 0% and 100%. A significant association between short cycle time and high relative wet time was noted. However, there was no relationship between the degree of automatization of the metal cutting machines and wet time. CONCLUSIONS: The study shows that skin exposure to cutting fluids can vary considerably between machine operators involved in manufacturing processes using different types of metal cutting machines. The machine type was not associated with dermal wetness. The technique appears to give objective information about dermal wetness.  (+info)

Offshore energy boom providing opportunities outside Medicare's umbrella. (51/51)

Physicians upset by limits imposed by the medicare system are getting a chance to spread their entrepreneurial wings on the East Coast. A boom in offshore exploration, led by Newfoundland's massive Hibernia project, has led to numerous business opportunities for physicians.  (+info)