Office reconditioning of stainless steel orthodontic attachments. (41/158)

An investigation was conducted to determine a simple, effective method for reconditioning stainless steel orthodontic attachments in the orthodontic office. In total, 100 new brackets were bonded to premolar teeth, then debonded and the bond strength recorded as a control for the reconditioning process. The debonded brackets were divided into six groups and each group reconditioned using different techniques as follows: attachments in four groups were flamed and then either (1) sandblasted, (2) ultrasonically cleaned, (3) ultrasonically cleaned followed by silane treatment, (4) rebonded without further treatment. Of the two remaining groups, one was sandblasted, while the brackets in the other were roughened with a greenstone. The brackets were rebonded to the premolar teeth after the enamel surfaces had been re-prepared, and their bond strengths measured. The results indicated that sandblasting was the most effective in removing composite without a significant change in bond strength compared with new attachments. Silane application did not improve the bond strength values of flamed and ultrasonically cleaned brackets. Attachments that had only been flamed had the lowest bond strength, followed by those that had been roughened with a greenstone.  (+info)

How do patients use their nebuliser in the community? (42/158)

BACKGROUND: Nebulised therapy is commonly used in the management of patients with asthma and chronic obstructive pulmonary disease (COPD). There are guidelines setting out standards for maintenance of the compressor and replacement and care of consumables. This study surveys patients using nebulisers to ascertain the reported use and maintenance of the nebulisers and any side effects related to therapy. METHODS: An anonymous postal questionnaire, requesting information on nebuliser use and maintenance, and side effects was sent to 200 patients who had been maintained on nebuliser therapy and had been in contact with the nebuliser service at Glasgow Royal Infirmary within the last year. RESULTS: One hundred and seventeen (58.5%) questionnaires were returned completed or partially completed for analysis. The majority of patients who replied were female (median age of 69 years). The most commonly reported diagnosis was COPD (87/117); 92/117 (79%) were smokers or ex-smokers. The most commonly reported side effects associated with treatment are dry mouth, tremor and chest tightness. The responses to questions on servicing, maintenance and replacement of consumables indicate that patients comply poorly with these activities. Additionally compliance with the prescribed drug regimen occurs in less than 50% of the patient cohort. CONCLUSIONS: The results of this study indicate that compliance with instructions given on the care and maintenance of home nebulisers may be suboptimal. Additionally patients reported poorer compliance than was predicted. These areas may be improved with the introduction of a new patient information leaflet.  (+info)

Factors influencing the discomfort of intraoral needle penetration. (43/158)

This study with 24 volunteers compared the discomfort produced by needle penetration in different parts of the palatal mucosa. In addition, comparing a fresh needle to one that was used for a previous penetration in the same patient, we assessed the influence of the status of the needle on insertion discomfort during buccal mucosal penetration. The results showed that needle penetration in the anterior hard palate was more uncomfortable than in the posterior palate. Although men could not differentiate between fresh and used needles for a second buccal mucosal penetration, women reported a significant increase in discomfort with used needles.  (+info)

Intravenous glucose preparation as the source of an outbreak of extended-spectrum beta-lactamase-producing Klebsiella pneumoniae infections in the neonatal unit of a regional hospital in KwaZulu-Natal. (44/158)

In the last week of May 2005, staff at Mahatma Gandhi Memorial Hospital in KwaZulu-Natal realised that many babies in the high-care nursery ward had bloodstream infections involving Klebsiella pneumoniae bacteria. Attempts to identify a common source of infection failed. The ward was therefore closed and new babies needing high care were admitted to another empty ward. Despite this, babies still became infected. This resulted in a request for assistance from the Department of Medical Microbiology of the Nelson R Mandela School of Medicine. A search for common factors through case history studies of the 26 infected babies showed that blood cultures of the babies remained positive despite the administration of appropriate antibiotics. Different options that could explain this were investigated. The organism was found in intravenous glucose preparations used for multiple dosing. Unopened vials of the same medication were sterile. The nursery was found to lack proper hand-wash facilities and to be overcrowded and understaffed. Reinforcement of hand hygiene and a ban on the multiple dosing of medicines stopped the outbreak. In conclusion, this outbreak resulted from a combination of factors among which lack of hand hygiene and multiple dosing of an intravenous glucose preparation were most significant.  (+info)

Molar band re-use and decontamination: a survey of specialists. (45/158)

OBJECTIVE: To determine the pattern of use and re-use of orthodontic molar bands, and examine infection control measures in a sample of UK orthodontists. DESIGN: Questionnaire survey. SUBJECTS AND METHODS: Questionnaires were sent to 204 individuals selected at random from the UK Specialist Orthodontist list. Follow-up questionnaires were sent to those that had not replied within 8 weeks. An overall response rate of 74.5% was achieved. MAIN OUTCOME MEASURES: Orthodontic band use and re-use and cross-infection control. RESULTS: The reported rates of pre-sterilization cleaning and sterilization of orthodontic instruments were 92 and 100%, respectively. Of the respondents, 90% were using bands for molar teeth with the remainder routinely used bonded attachments. Most clinicians (95%) using bands routinely re-used them after being tried-in with 5% discarding them. Pre-sterilization cleaning of re-used molar bands was carried out by 92% of respondents who reclaimed bands. Sterilization of these bands was then carried out by most specialists apart from 2. CONCLUSIONS: The majority of UK specialist orthodontists who responded to the questionnaire are adhering to universal precautions for cross-infection control and are carrying out approved decontamination procedures. The majority are also reusing orthodontic bands that have been tried in the mouth, but found to be the wrong size. The great diversity of reported procedures for decontamination of instruments and bands suggest that more research is required to provide guidelines into the most effective method.  (+info)

Cleaning and disinfection in gastrointestinal endoscopy: current status in Romania. (46/158)

BACKGROUND: Today, endoscopic procedures have become an important tool in the diagnosis and treatment of gastrointestinal diseases. In order to prevent cross infections, the cleaning and disinfection/sterilisation procedures of the endoscopes and accessories are primordial. The GOAL of this paper was to assess the way and the conditions in which endoscopic disinfection is achieved in our country. METHODS: A study-type questionnaire with eighteen questions, about reprocessing of flexible endoscopes and accessories, was addressed to 37 centres from Romania known to perform digestive endoscopy. RESULTS: Twenty-nine centres (78.37%) answered the questionnaire. In all the cases, the reprocessing is based on pre-established protocols and the endoscopy nurse has the principal responsibility (62.06%). Enzymatic type detergents are available in 75.86% and glutaraldehyde is the most used disinfector (55.17%). The costs (41.38%) and the financial resources (27.6%) are considered when selecting a product. Despite their advantages, automatic-disinfectors are available in only 34.48% of the cases. All the participants in the study (100%) reused endoscopic instruments, but only 31.03% used them after sterilization by steam autoclaving or ethylene oxide. Adequate facilities for manipulating potential toxic solutions are assured in 48.27%, but separate purpose-designed rooms are available in only 27.58%. Most centres (86.20%) regularly control the quality of the cleaning and disinfection by sampling. CONCLUSIONS: In general, the disinfection and sterilization of the endoscopes and accessories are carried out in good conditions. With regard to European Union integration, adequate facilities and funds are required to improve the reprocessing activity.  (+info)

Shear bond strength of new and recycled brackets to enamel. (47/158)

The purpose of this study was to evaluate in vitro the shear bond strength of recycled orthodontic brackets. S2C-03Z brackets (Dental Morelli, Brazil) were bonded to the buccal surfaces of 50 extracted human premolars using Concise Orthodontic chemically cured composite resin (3M, USA). The teeth were randomly assigned to 5 groups (n=10), as follows. In group I (control), the bonded brackets remained attached until shear testing (i.e., no debonding/rebonding). In groups II, III and IV, the bonded brackets were detached and rebonded after recycling by 90-microm particle aluminum oxide blasting, silicon carbide stone grinding or an industrial process at a specialized contractor company (Abzil-Lancer, Brazil), respectively. In group V, the bonded brackets were removed and new brackets were bonded to the enamel surface. Shear bond strength was tested in an Instron machine at a crosshead speed of 0.5 mm/min. Data were analyzed statistically by ANOVA and Tukey's test at 5% significance level. There was no statistically significant difference (p>0.05) between the control brackets (0.52 kgf/mm2), brackets recycled by aluminum oxide blasting (0.34 kgf/mm2) and new brackets attached to previously bonded teeth (0.43 kgf/mm2). Brackets recycled by the specialized company (0.28 kgf/mm2) and those recycled by silicon carbide stone grinding (0.14 kgf/mm2) showed the lowest shear strength means and differed statistically from control brackets (0.52 kgf/mm2) (p<0.05). In conclusion, the outcomes of this study showed that bracket recycling using 90-microm aluminum oxide particle air-abrasion was efficient and technically simple, and might provide cost reduction for orthodontists and patients alike.  (+info)

Gastrointestinal endoscopes cleaned without detergent substance following an automated endoscope washer/disinfector dysfunction. (48/158)

OBJECTIVE: To report cases of gastrointestinal endoscopies performed with endoscopes that were reprocessed without detergent substance during a period of dysfunction of the automated endoscope reprocessor (AER). METHOD: A dysfunction of the AER for the cycles requiring detergent substance was reported at the Grenoble University Hospital on March 2005. During this period, 72 patients had potentially been exposed to a contaminated endoscope. A recall procedure was organized and serologic tests (HIV, HCV, HBV) were performed 3 and 6 months after the AER incident. RESULTS: Within the 72 patients convened, 56 (77.8%) were seen in consultation and accepted the serologic screening. Finally, serologic screening was done for 59 patients (81.9%) and no seroconversion for HIV, HCV, or HBV was observed. The final attrition rate was 13 patients (18.1%). CONCLUSION: No viral infection was transmitted during the AER dysfunction. After this AER incident, the monitoring of the endoscopic procedures and the traceability of the cleaning process were both improved to prevent further incidents.  (+info)