Deposition of calcium pyrophosphate in tissue after revision arthroplasty of the hip.
(25/2752)
We reviewed histologically the incidence and pathogenesis of the deposition of calcium pyrophosphate dihydrate (CPPD) crystals in the pseudocapsule, femoral and acetabular membranes and periprosthetic tissue at revision of 789 cases of failed total hip replacement. In 13, periprosthetic tissues were found to have deposits of CPPD crystals in areas of cartilaginous metaplasia; four also showed evidence of localised deposition of amyloid. None of the patients had a history of chondrocalcinosis in the hip or other joints. Cartilaginous metaplasia and other changes in periprosthetic tissues may predispose to the deposition of CPPD and associated localised amyloid. (+info)
A prospective study of changes in aneurysm and graft length after endovascular exclusion of AAA using balloon and self-expanding endograft systems.
(26/2752)
PURPOSE: Longitudinal shrinkage of aneurysms post-endovascular repair, employing unvalidated measurement techniques has been held to account for endograft disruption. In this study we record changes in aneurysm length, diameter and volume using the gold standard of calibrated spiral CT angiography (SCTA). METHOD: From 179 patients with AAA scanned by SCTA, 68 were selected for endografting. Twenty-seven had PTFE home-made prostheses while 41 patients had Talent endografts. SCTA was performed on the fifth postoperative day and 6-monthly intervals thereafter. The distance between the lowest renal artery and the aortic bifurcation (VBL - vertical body length) and the luminal centre line length (LCL) were measured. Maximal sac diameters and volumes were recorded using 3DCT reconstruction. RESULTS: Significant increase was noted in VBL (3.2) mm for PTFE-treated patients accompanied by an increase in sac volume at day 5 (12.5 ml). No changes in LCL or maximal diameters were evident. At 1.5 years further lengthening of both VBL (6.4 mm) and LCL (9.3 mm) was unaccompanied by sac diameter/volume changes. Talent patients - no changes in VBL or LCL were evident. Volumes and maximal AP and transverse diameters showed marked shrinkage: AP -11. 2 mm; transverse -2.6 mm; volumes by -35.5 ml at 6 months. CONCLUSION: With PTFE increase in VBL but not graft length, without concurrent changes in maximal diameters at day 5, is commensurate with increase in sac volume; after 1.5 years graft lengthening overtakes aortic lengthening. In Talent patients VBL/graft length remained unchanged. There is no evidence for longitudinal aneurysmal contracture. Volumes and maximal diameters for the Talent endograft but not for PTFE show shrinkage. (+info)
Incomplete and inaccurate death certification--the impact on research.
(27/2752)
BACKGROUND: The objectives of this study were (1) to investigate the extent of erroneous and/or omitted information on death certificates of patients-implanted with Bjork-Shiley Convexo-Concave (BSCC) heart valves; (2) to determine whether this information could be associated with a possible under-reporting of acute mechanical failure of this valve. METHODS: A review was carried out of death certificates and clinical notes for patients implanted in the United Kingdom with BSCC valves. This was a multicentre study (38 hospitals) based at the Cardiothoracic Department, NHLI, Imperial College School of Medicine at Hammersmith Hospital, London. The subjects were 478 patients implanted with a BSCC valve between 1979 and 1986 who died in the following years: 1984, 1987, 1990, 1993 and 1996. The main outcome measures were: (1) percentage of death certificates that record the presence of a valve prosthesis; (2) percentage of death certificates that record the presence of a valve prosthesis for patients who had a post mortem; (3) percentage of death certificates that record inaccurate or incomplete information related to the surgery; (4) percentage of death certificates that do not record a post mortem where one is known to have been performed. RESULTS: Twenty-one per cent (101/478) of the total number of death certificates record the presence of the valve prosthesis. Thirty-five per cent (43/123) of the death certificates for patients who had a post mortem record the presence of a valve prosthesis. Six per cent (30/478) of death certificates report inaccurate information related to the valve surgery. Twenty-five per cent (118/478) of the total number of death certificates recorded a single cause of death. Twenty-three per cent (110/478) of all death certificates reviewed recorded only the mode of dying. Eight per cent (10/123) of the total number of death certificates for patients who had a post mortem did not record a post mortem. CONCLUSIONS: The relatively high number of death certificates that do not record the presence of a valve prosthesis and the observed under-reporting of post mortems may lead to inaccurate reporting of the number of BSCC valves that fail. Previous recommendations to improve accuracy in death certification appear to have gone unheeded, and changes in the way certificates are completed for patients with implanted cardiac devices should be considered. (+info)
Wear debris from two different alumina-on-alumina total hip arthroplasties.
(28/2752)
We compared wear particles from two different designs of total hip arthroplasty with polycrystalline alumina-ceramic bearings of different production periods (group 1, before ISO 6474: group 2, according to ISO 6474). The neocapsules and interfacial connective tissue membranes were retrieved after mean implantation times of 131 months and 38 months, respectively. Specimen blocks were freed from embedding media, either methylmethacrylate or paraffin and digested in concentrated nitric acid. Particles were then counted and their sizes and composition determined by SEM and energy-dispersive x-ray analysis (EDXA). The mean numbers and sizes of most alumina wear particles did not differ for both production periods, but the larger sizes of particle in group 1 point to more severe surface destruction. The increased metal wear in group 2 was apparently due to alumina-induced abrasion of the stems. In this study the concentrations of particles in the periprosthetic tissues were 2 to 22 times lower than those observed previously with polyethylene and alumina/polyethylene wear couples. (+info)
Femoral prosthetic heads and their significance in polyethylene wear.
(29/2752)
We used scanning electron microscopy to perform an ultrastructural analysis and two optical interferometric profilers to measure roughness on 40 prosthetic femoral heads. We expressed roughness as Ra (roughness average) value and Rsk (roughness skewness) value. Our results show that in order to obtain an ideal surface finish a low or not very high Ra value and a negative Rsk value are needed. The presence of depressions or holes (rather than scratches) with smooth (rather than sharp) edges seems to improve the lubrication and wettability properties. (+info)
Influence of ceramic and stainless steel brackets on the notching of archwires during clinical treatment.
(30/2752)
The surface topography of 100 clinically used archwires of stainless steel, beta-, or nickel-titanium were investigated that had contacted either ceramic or stainless steel brackets. One group consisted of two sets: 60 wires with no treatment records accessed to bias analyses, and 40 wires for which extensive clinical records were available, half of which were used with ceramic or stainless steel brackets. A control group consisted of two sets: 30 unused wires comprised of five round and rectangular wires of each alloy, and four wires that were ligated and immediately removed from patients' mouths. After ultrasonic cleaning, each wire was inspected under an optical and/or a scanning electron microscope. Notches were categorized with regard to frequency, patterns, and severity, and mapped as a function of wire aspect (lingual, facial, and occlusal/gingival) and anatomical regions (molar, premolar, canine, and incisor). From these data the average severity of notch patterns and a notching index were derived. Although no recognizable defect patterns were observed in the control group, seven basic patterns were recognized for each wire cross-sectional shape in the clinically used wires. These wires appeared most damaged on their lingual aspect and least damaged on their facial aspect. With regard to anatomical regions, notching was prevalent in the anterior regions and sparse in the molar regions. The notch activity and the severity were nearly three times greater from ceramic brackets than from stainless steel brackets. Over one-third of all notches documented in ceramic bracket cases had severity numbers of 3 and penetrated at least one-quarter of each wire's dimension, However, over two-thirds of all notches documented in stainless steel bracket cases had severity numbers of 1. From these tabulations a theory of notch formation was proposed in which vertical movement from tooth or wire during mastication caused fretting wear, and horizontal movement during orthodontic procedures such as space closure, tipping, or bodily movement caused sliding wear. (+info)
Proximal femoral bone loss and increased rate of fracture with a proximally hydroxyapatite-coated femoral component.
(31/2752)
We performed a retrospective analysis of the clinical and radiological outcomes of total hip replacement using an uncemented femoral component proximally coated with hydroxyapatite. Of 136 patients, 118 who had undergone 124 primary total hip replacements were available for study. Their mean age was 66.5 years (19 to 90) and the mean follow-up was 5.6 years (4.25 to 7.25). At the final follow-up the mean Harris hip score was 92 (47.7 to 100). Periprosthetic femoral fractures, which occurred in seven patients (5.6%), were treated by osteosynthesis in six and conservatively in one. We had to revise five femoral components, one because of aseptic loosening, one because of septic loosening and three because of periprosthetic fracture. At the final follow-up there were definite signs of aseptic loosening in two patients. Radiologically, proximal femoral bone loss in Gruen zones I and VI was evident in 96.8% of hips, while bone hypertrophy in zones III and V was seen in 64.7%. In 24 hips (20.2%) the mean subsidence of the stem was 3.7 mm which occurred within the first 12 postoperative weeks. This indicated poor initial stability, which might have been aggravated by early weight-bearing. The high rate of failure in our study suggests that proximal femoral bone loss affects the long-term survival of the replacement. (+info)
The skeletal response to matt and polished cemented femoral stems.
(32/2752)
We studied the effect of the surface finish of the stem on the transfer of load in the proximal femur in a sheep model of cemented hip arthroplasty. Strain-gauge analysis and corresponding finite-element (FE) analysis were performed to assess the effect of friction and creep at the cement-stem interface. No difference was seen between the matt and polished stems. FE analysis showed that the effects of cement creep and friction at the stem-cement interface on femoral strain were small compared with the effect of inserting a cemented stem. (+info)