Procedure for calibrating the Technicon Colorimeter I. (1/29)

We describe a rapid method for calibrating the Technicon AutoAnalyzer colorimeter I. Test solutions of bromphenol blue are recommended for the calibration, in preference to solutions of potassium dichromate, based on considerations of the instrument's working range and of the stray light characteristics of the associated filters.  (+info)

Guidance for selecting the measurement conditions in the dye-binding method for determining serum protein: theoretical analysis based on the chemical equilibrium of protein error. (2/29)

A methodology for selecting the measurement conditions in the dye-binding method for determining serum protein has been studied by a theoretical calculation. This calculation was based on the fact that a protein error occurs because of a reaction between the side chains of a positively charged amino acid residue in a protein molecule and a dissociated dye anion. The calculated characteristics of this method are summarized as follows: (1) Although the reaction between the dye and the protein occurs up to about pH 12, a change in the color shade, called protein error, is observed only in a pH region restricted within narrow limits. (2) Although the apparent absorbance (the absorbance of the test solution measured against a reagent blank) is lower than the true absorbance indicated by the formed dye-protein complex, the apparent absorbance correlates with the true absorbance with a correlation coefficient of 1.0. (3) At a higher dye concentration, the calibration curve is more linear at a higher pH than at a lower pH. Most of these characteristics were similarly observed experimentally in the reactions of BPB, BCG and BCP with human and bovine albumins. It is concluded that in order to ensure the linearity of the calibration curve, the measurement should be performed at a higher dye concentration and sufficiently high pH where the detection sensitivity is satisfied.  (+info)

Microfluidic large-scale integration. (3/29)

We developed high-density microfluidic chips that contain plumbing networks with thousands of micromechanical valves and hundreds of individually addressable chambers. These fluidic devices are analogous to electronic integrated circuits fabricated using large-scale integration. A key component of these networks is the fluidic multiplexor, which is a combinatorial array of binary valve patterns that exponentially increases the processing power of a network by allowing complex fluid manipulations with a minimal number of inputs. We used these integrated microfluidic networks to construct the microfluidic analog of a comparator array and a microfluidic memory storage device whose behavior resembles random-access memory.  (+info)

Preparation of sand fly (Diptera: Psychodidae: Phlebotominae) specimens for histological studies. (4/29)

Phlebotominae sand fly specimens were prepared for histological and physiological studies. Different fixatives were tested on sectioned and whole bodied adult females in order to obtain good fixation and provide satisfactory penetration of the embedding media. All fixed specimens were infiltrated (up to seven days under 5 C) and embedded in hydroxyethyl metacrylate. Two-three m sections were stained, mounted in Canada balsam and observed by light microscopy. Best results were achieved when whole bodied insects were double fixed in Bouin's and Carnoy's fluids (4 h/2 h) and stained in Hematoxilin/Eosin or fixed in calcium formaldehyde and stained in mercury bromophenol blue.  (+info)

Purification and characterization of an aflatoxin degradation enzyme from Pleurotus ostreatus. (5/29)

Nineteen fungi were tested for their ability to degrade aflatoxin B1 (AFB1). An extracellular enzyme from the edible mushroom Pleurotus ostreatus showed afaltoxin-degradation activity detected by thin-layer chromatography (TLC). An enzyme with this activity was purified by two chromatographies on DEAE-Sepharose and Phenyl-Sepharose. The apparent molecular mass of the purified enzyme was estimated to be 90 kDa by SDS-PAGE. Optimum activities were found in the pH range between 4.0 and 5.0 and at 25 degrees C. Also, degradation activity of several dyes in the presence of H2O2 was tested, resulting in the detection of bromophenol blue-decolorizing activity. Based on these data, we suggest this enzyme is a novel enzyme with aflatoxin-degradation activity. Fluorescence measurements suggest that the enzyme cleaves the lactone ring of aflatoxin.  (+info)

Delivery of several forms of DNA, DNA-RNA hybrids, and dyes across human sclera by electrical fields. (6/29)

PURPOSE: Iontophoresis has been used for drug delivery across the cornea for many years. We sought to test whether small charged dyes and DNA can be transferred across human sclera by an electric field. METHODS: Full-thickness human scleral fragments were embedded vertically in an agarose gel and positioned to completely span individual gel lanes. The scleral fragments were located approximately 1 cm downstream from the gel wells. DNA or dyes were loaded into the wells and electrophoresis was carried out at about 3.3 V/cm for approximately 2 h per run. Movement of DNA and dyes through the agarose and sclera was measured with either digital time-lapse photography or through DNA extraction and purification from the gel. SYBR green stain was used as a sensitive method to detect DNA. RESULTS: Digital time-lapse photography of agarose gel electrophoresis revealed that two dyes, xylene cyanol and bromphenol blue, passed through the sclera in the presence of an electric field. Xylene cyanol was driven through the sclera virtually unimpeded except for some spreading of the dye. Bromphenol blue was slowed markedly by the sclera, but it too eventually passed through the tissue. Small DNAs, including a single stranded 51-mer and a double hairpin 68-mer oligonucleotide, passed through the sclera as detected by SYBR green staining. Linear double stranded DNAs ranging from 50 bp to 12,000 bp passed through the sclera. The larger the DNA, the slower the rate of passage through the sclera, and the greater the band spreading. pEGFP-1 (a 3 kb plasmid) passed through the sclera but was accompanied by a great amount of band spreading. Following completion of the initial electrophoresis run, the plasmid DNA was extracted from the smeared bands in the agarose distal to the sclera and re-run on a second gel without sclera. The initially smeared plasmid bands resolved into 2 distinct bands after extraction and purification and matched well with control plasmid bands. CONCLUSIONS: Charged molecules such as xylene cyanol, bromphenol blue, and DNAs ranging from 51 bp oligonucleotides to a 3 kb plasmid can be driven across human sclera by an electric field and directly detected. Passage of plasmids was efficient, but the plasmid bands were diffuse after transit. This technique offers promise as a noninvasive DNA delivery tool, where gene therapy can be accomplished by small RNA or DNA synthetic oligonucleotides, larger double stranded fragments, or even plasmids.  (+info)

Theoretical analysis concerning the characteristics of a dye-binding method for determining serum protein based on protein error of pH indicator: effect of buffer concentration of the color reagent on the color development. (7/29)

In the dye-binding method based on protein error of a pH indicator, the color development has been reported to be markedly affected by the buffer concentration of the color reagent. In this study, the author analyzed this phenomenon by a theoretical calculation based on the chemical equilibrium of protein error. The calculation was performed on the assumption that both the dissociated dye anion and the anion contained in the buffer solution react with protein, forming a dye-protein complex and an anion-protein complex, respectively. The calculated results were compared with those obtained by the experiments using bromophenol blue, bromocresol green and bromocresol purple that are employed widely for determining the human serum albumin concentration clinically. The calculated results of this method are summarized as follows: (1) the color development decreases with the increase in the concentration of the anion contained in the buffer solution; (2) the calibration curve is more linear in the higher concentration of the anion than in the lower one. These calculated results agreed well with the experimental ones. From these results, it was concluded that the change in the color development by the buffer concentration of the color reagent is due to the change in the concentration of the buffer anion.  (+info)

An evaluation of novel vital dyes for intraocular surgery. (8/29)

PURPOSE: To evaluate systematically the staining characteristics and safety of potential new dyes for intraocular surgery. METHODS: Six dyes were included in the investigation: light green SF (LGSF) yellowish, E68, bromophenol blue (BPB), Chicago blue (CB), rhodamine 6G, rhodulinblau-basic 3 (RDB-B3). All dyes were dissolved and diluted in a balanced saline saline solution. The light-absorbing properties of each dye were measured at a concentration of 0.05% between 200 and 1000 nm. Staining characteristics were examined by staining lens capsule tissue and epiretinal membranes (ERMs), removed intraoperatively, with dye concentrations of 1.0%, 0.5%, 0.2%, and 0.05%. Enucleated porcine eyes (postmortem time, 9 hours) were also stained. Dye-related toxicity was evaluated by a colorimetric test (MTT) measuring the inhibition of retinal pigment epithelium (RPE) cell proliferation (ARPE-19 and primary human RPE cells, passages 3-6). Cell viability was also quantified based on a two-color fluorescence cell-viability assay. Dyes were investigated in concentrations of 0.2% and 0.02%. RESULTS: All dyes investigated in this study stained human lens capsules, removed intraoperatively; ERMs, peeled during macular pucker surgery; and enucleated porcine eyes, depending on the concentration applied. The long-wavelength absorption maximum of the dyes was within the range of 527 to 655 nm at concentrations of 0.05%. Rhodamine G6 and RDB-B3 showed adverse effects on ARPE-19 cell proliferation at a concentration of 0.2% and were excluded from further investigation in primary RPE cells. The remaining four dyes showed no toxic effect on ARPE-19 and primary RPE cell proliferation at concentrations of 0.2% and 0.02%. Cell viability was affected by LGSF yellowish (0.2%) and CB (0.2% and 0.02%). Two dyes (E68 and BPB) showed no relevant toxicity in vitro. CONCLUSIONS: The systematic evaluation of dyes for intraocular use seems mandatory. In this study four dyes were identified with effective staining characteristics, with two of these dyes having no detectable toxic effect on RPE cells in vitro.  (+info)