Constraints on models for the flagellar rotary motor. (25/1292)

Most bacteria that swim are propelled by flagellar filaments, each driven at its base by a rotary motor embedded in the cell wall and cytoplasmic membrane. A motor is about 45 nm in diameter and made up of about 20 different kinds of parts. It is assembled from the inside out. It is powered by a proton (or in some species, a sodium-ion) flux. It steps at least 400 times per revolution. At low speeds and high torques, about 1000 protons are required per revolution, speed is proportional to protonmotive force, and torque varies little with temperature or hydrogen isotope. At high speeds and low torques, torque increases with temperature and is sensitive to hydrogen isotope. At room temperature, torque varies remarkably little with speed from about -100 Hz (the present limit of measurement) to about 200 Hz, and then it declines rapidly reaching zero at about 300 Hz. These are facts that motor models should explain. None of the existing models for the flagellar rotary motor completely do so.  (+info)

Theories of rotary motors. (26/1292)

The bacterial flagellar motor and the ATP-hydrolysing F1 portion of the F1Fo-ATPase are known to be rotary motors, and it seems highly probable that the H+-translocating Fo portion rotates too. The energy source in the case of Fo and the flagellar motor is the flow of ions, either H+ (protons) or Na+, down an electrochemical gradient across a membrane. The fact that ions flow in a particular direction through a well-defined structure in these motors invites the possibility of a type of mechanism based on geometric constraints between the rotor position and the paths of ions flowing through the motor. The two best-studied examples of such a mechanism are the 'turnstile' model of Khan and Berg and the 'proton turbine' model of Lauger or Berry. Models such as these are typically represented by a small number of kinetic states and certain allowed transitions between them. This allows the calculation of predictions of motor behaviour and establishes a dialogue between models and experimental results. In the near future structural data and observations of single-molecule events should help to determine the nature of the mechanism of rotary motors, while motor models must be developed that can adequately explain the measured relationships between torque and speed in the flagellar motor.  (+info)

Influence of sulfide and temperature on species composition and community structure of hot spring microbial mats. (27/1292)

In solfataric fields in southwestern Iceland, neutral and sulfide-rich hot springs are characterized by thick bacterial mats at 60 to 80 degrees C that are white or yellow from precipitated sulfur (sulfur mats). In low-sulfide hot springs in the same area, grey or pink streamers are formed at 80 to 90 degrees C, and a Chloroflexus mat is formed at 65 to 70 degrees C. We have studied the microbial diversity of one sulfur mat (high-sulfide) hot spring and one Chloroflexus mat (low-sulfide) hot spring by cloning and sequencing of small-subunit rRNA genes obtained by PCR amplification from mat DNA. Using 98% sequence identity as a cutoff value, a total of 14 bacterial operational taxonomic units (OTUs) and 5 archaeal OTUs were detected in the sulfur mat; 18 bacterial OTUs were detected in the Chloroflexus mat. Although representatives of novel divisions were found, the majority of the sequences were >95% related to currently known sequences. The molecular diversity analysis showed that Chloroflexus was the dominant mat organism in the low-sulfide spring (1 mg liter(-1)) below 70 degrees C, whereas Aquificales were dominant in the high-sulfide spring (12 mg liter(-1)) at the same temperature. Comparison of the present data to published data indicated that there is a relationship between mat type and composition of Aquificales on the one hand and temperature and sulfide concentration on the other hand.  (+info)

Male-killing bacteria in insects: mechanisms, incidence, and implications. (28/1292)

Bacteria that are vertically transmitted through female hosts and kill male hosts that inherit them were first recorded in insects during the 1950s. Recent studies have shown these "male-killers" to be diverse and have led to a reappraisal of the biology of many groups of bacteria. Rickettsia, for instance, have been regarded as human pathogens transmitted by arthropods. The finding of a male-killing Rickettsia obligately associated with an insect suggests that the genus' members may be primarily associated with arthropods and are only sometimes pathogens of vertebrates. We examined both how killing of male hosts affects the dynamics of inherited bacteria and how male-killing bacteria affect their host populations. Finally, we assessed the potential use of these microorganisms in the control of insect populations.  (+info)

A simple, rapid method for demonstrating bacterial flagella. (29/1292)

We developed a simple, rapid method for demonstrating flagellation of bacteria using the fluorescent protein stain NanoOrange (Molecular Probes, Eugene, Oreg.). The NanoOrange reagent binds to hydrophobic regions of proteins, which results in substantial enhancement of fluorescence. Unbound reagent is essentially nonfluorescent. NanoOrange fluorescently stained bacterial cell bodies, as well as flagella and other appendages, which could be directly observed by epifluorescence microscopy. Detection of flagella was further improved by using a charge-coupled device camera for image capture and processing. The reliability of the method was tested by using 37 pure cultures of marine bacteria. Detection of flagella on the isolates by NanoOrange staining was compared to detection by transmission electron microscopy (TEM). For 36 of 37 cultures, the two methods yielded the same results. In one case, flagella were detected by TEM but not by NanoOrange, although the difference may be attributable to differences between the culture preparations. NanoOrange staining is rapid (10 to 15 min) and does not require fixation or dehydration, so live samples can be stained. Since NanoOrange is a general protein stain and works directly in seawater, it may also prove to be useful for staining other proteinaceous material that is of interest to aquatic microbial ecologists.  (+info)

Natural selection, infectious transfer and the existence conditions for bacterial plasmids. (30/1292)

Despite the near-ubiquity of plasmids in bacterial populations and the profound contribution of infectious gene transfer to the adaptation and evolution of bacteria, the mechanisms responsible for the maintenance of plasmids in bacterial populations are poorly understood. In this article, we address the question of how plasmids manage to persist over evolutionary time. Empirical studies suggest that plasmids are not infectiously transmitted at a rate high enough to be maintained as genetic parasites. In part i, we present a general mathematical proof that if this is the case, then plasmids will not be able to persist indefinitely solely by carrying genes that are beneficial or sometimes beneficial to their host bacteria. Instead, such genes should, in the long run, be incorporated into the bacterial chromosome. If the mobility of host-adaptive genes imposes a cost, that mobility will eventually be lost. In part ii, we illustrate a pair of mechanisms by which plasmids can be maintained indefinitely even when their rates of transmission are too low for them to be genetic parasites. First, plasmids may persist because they can transfer locally adapted genes to newly arriving strains bearing evolutionary innovations, and thereby preserve the local adaptations in the face of background selective sweeps. Second, plasmids may persist because of their ability to shuttle intermittently favored genes back and forth between various (noncompeting) bacterial strains, ecotypes, or even species.  (+info)

Proposal of Oscillochloridaceae fam. nov. on the basis of a phylogenetic analysis of the filamentous anoxygenic phototrophic bacteria, and emended description of Oscillochloris and Oscillochloris trichoides in comparison with further new isolates. (31/1292)

The nucleotide sequences of the genes of 16S rRNAs were determined for the type strain Oscillochloris trichoides DG-6T and three new strains of Oscillochloris-like mesophilic filamentous green bacteria. Two major clusters have been found within the family Chloroflexaceae by phylogenetic-analysis: one cluster includes thermophilic species of Chloroflexus and the second includes mesophilic strains of Oscillochloris. The degree of relatedness of these clusters was below an intergeneric level, having only 82.5-86.5% of 16S rDNA sequence similarity. These phylogenetic data correlate well with the significant physiological, biochemical and chemotaxonomical differences between members of both groups. Therefore, the Oscillochloris and Chloroflexus clusters should be considered as two separate families. The description of the new family, Oscillochloridaceae fam. nov., and emended descriptions of the genus Oscillochloris and the species Oscillochloris trichoides are presented.  (+info)

Structural and genomic correlates of hyperthermostability. (32/1292)

While most organisms grow at temperatures ranging between 20 and 50 degrees C, many archaea and a few bacteria have been found capable of withstanding temperatures close to 100 degrees C, or beyond, such as Pyrococcus or Aquifex. Here we report the results of two independent large scale unbiased approaches to identify global protein properties correlating with an extreme thermophile lifestyle. First, we performed a comparative proteome analyses using 30 complete genome sequences from the three kingdoms. A large difference between the proportions of charged versus polar (noncharged) amino acids was found to be a signature of all hyperthermophilic organisms. Second, we analyzed the water accessible surfaces of 189 protein structures belonging to mesophiles or hyperthermophiles. We found that the surfaces of hyperthermophilic proteins exhibited the shift already observed at the genomic level, i.e. a proportion of solvent accessible charged residues strongly increased at the expense of polar residues. The biophysical requirements for the presence of charged residues at the protein surface, allowing protein stabilization through ion bonds, is therefore clearly imprinted and detectable in all genome sequences available to date.  (+info)