Inhalation carcinogenicity and chronic toxicity of indium-tin oxide in rats and mice.
(74/144)
OBJECTIVES: Carcinogenicity and chronic toxicity of indium-tin oxide (ITO) were examined by inhalation exposure of rats and mice to ITO aerosol. METHODS: Fifty mice of both sexes were exposed to ITO at 0 (control), 0.01, 0.03 or 0.1 mg/m(3) for 6 h/day, 5 day/wk for 104 wk, and 50 rats of both sexes were exposed to 0, 0.01 or 0.03 mg/m(3) ITO for the same time period. The repeated exposure of 50 rats of both sexes to 0.1 mg/m(3) ITO was discontinued at the 26th wk, followed by clean air exposure for the remaining 78 wk. RESULTS: In rats, incidences of bronchiolo-alveolar adenomas and carcinomas, bronchiolo-alveolar hyperplasia, alveolar wall fibrosis and thickened pleural wall, alveolar proteinosis and infiltrations of alveolar macrophages and inflammatory cells were significantly increased. Combined incidences of malignant lung tumors in male rats and total lung tumors in male and female rats were significantly increased at exposure to 0.01 mg/m(3) ITO. In mice, no carcinogenic response occurred, but thickened pleural wall, alveolar proteinosis and alveolar macrophage infiltration were induced. Mice were less susceptible to ITO than rats. The lung content of indium was the greatest, followed by the spleen, kidney and liver. Blood indium levels increased dose-dependently. CONCLUSIONS: There was clear evidence of carcinogenicity of inhaled ITO in male and female rats but not clear evidence in mice, together with occurrence of the chronic pulmonary lesions in both rats and mice. (+info)
A glucose sensor fabricated by piezoelectric inkjet printing of conducting polymers and bienzymes.
(75/144)
Piezoelectric inkjet printing of polymers and proteins holds great promise for fabrication of miniaturized bioelectronic devices, such as biochips and biosensors. In this study, a bienzymatic glucose biosensor prototype based on poly(3,4-ethylenedioxythiophene)-poly(styrene sulfonic acid) (PEDOT-PSS), glucose oxidase (GOD), and horseradish peroxidase (HRP) was fabricated by a piezoelectric inkjet printer. An aqueous bioelectrical ink containing PEDOT-PSS, GOD, and HRP was prepared and printed on an indium-tin-oxide (ITO)-coated poly(ethylene terephthalate) (PET) film. The PEDOT-PSS/GOD/HRP sensor was covered with a cellulose acetate membrane. The use of bienzymatic sensing combined with conducting polymers via piezoelectric inkjet printing showed a synergistic effect resulting in significant amplification of the response signal. The glucose sensor reached steady-state current density within 3 s, indicating a fast response time, and exhibited a linear dose-dependent electrochemical response with high sensitivity. The overall result demonstrates that a glucose sensor with high sensitivity could be readily fabricated by a piezoelectric inkjet printing system. (+info)
Nano-structured nickel oxide based DNA biosensor for detection of visceral leishmaniasis (Kala-azar).
(76/144)