Different regulation of the p53 core domain activities 3'-to-5' exonuclease and sequence-specific DNA binding.
(1/552)
In this study we further characterized the 3'-5' exonuclease activity intrinsic to wild-type p53. We showed that this activity, like sequence-specific DNA binding, is mediated by the p53 core domain. Truncation of the C-terminal 30 amino acids of the p53 molecule enhanced the p53 exonuclease activity by at least 10-fold, indicating that this activity, like sequence-specific DNA binding, is negatively regulated by the C-terminal basic regulatory domain of p53. However, treatments which activated sequence-specific DNA binding of p53, like binding of the monoclonal antibody PAb421, which recognizes a C-terminal epitope on p53, or a higher phosphorylation status, strongly inhibited the p53 exonuclease activity. This suggests that at least on full-length p53, sequence-specific DNA binding and exonuclease activities are subject to different and seemingly opposing regulatory mechanisms. Following up the recent discovery in our laboratory that p53 recognizes and binds with high affinity to three-stranded DNA substrates mimicking early recombination intermediates (C. Dudenhoeffer, G. Rohaly, K. Will, W. Deppert, and L. Wiesmueller, Mol. Cell. Biol. 18:5332-5342), we asked whether such substrates might be degraded by the p53 exonuclease. Addition of Mg2+ ions to the binding assay indeed started the p53 exonuclease and promoted rapid degradation of the bound, but not of the unbound, substrate, indicating that specifically recognized targets can be subjected to exonucleolytic degradation by p53 under defined conditions. (+info)
The cyclic structure of microcin J25, a 21-residue peptide antibiotic from Escherichia coli.
(2/552)
Microcin J25 (MccJ25) is the single representative of the immunity group J of the microcin group of peptide antibiotics produced by Enterobacteriaceae. It induces bacterial filamentation in susceptible cells in a non-SOS-dependent pathway [R. A. Salomon and R. Farias (1992) J. Bacteriol. 174, 7428-7435]. MccJ25 was purified to homogeneity from the growth medium of a microcin-overproducing Escherichia coli strain by reverse-phase HPLC. Based on amino acid composition and absolute configuration determination, liquid secondary ion and electrospray mass spectrometry, extensive two-dimensional NMR, enzymatic and chemical degradations studies, the structure of MccJ25 was elucidated as a 21-residue peptide, cyclo(-Val1-Gly-Ile-Gly-Thr- Pro-Ile-Ser-Phe-Tyr-Gly-Gly-Gly-Ala-Gly-His-Val-Pro-Glu-Tyr-Phe21- ). Although MccJ25 showed high resistance to most of endoproteases, linearization by thermolysin occurred from cleavage at the Phe21-Val1 bond and led to a single peptide, MccJ25-L. While MccJ25 exhibited remarkable antibiotic activity towards Salmonella newport and several E. coli strains (minimal inhibitory concentrations ranging between 0.01 and 0.2 microgram.mL-1), the thermolysin-linearized microcin showed a dramatic decrease of the activity, indicating that the cyclic structure is essential for the MccJ25 biological properties. As MccJ25 is ribosomally synthesized as a larger peptide precursor endowed with an N-terminal extremity, the present study shows that removal of this extension and head-tail cyclization of the resulting propeptide are the only post-translational modifications involved in the maturation of MccJ25, that appears as the first cyclic microcin. (+info)
Studies on the formation and stability of a complex between Streptomyces proteinaceous metalloprotease inhibitor and thermolysin.
(3/552)
The effects of certain physicochemical parameters on the formation and stability of a complex between Streptomyces proteinaceous metalloprotease inhibitor (SMPI) and thermolysin were investigated. SMPI had its lowest Ki value at a pH of around 6.5 (similar to the pH dependence of the kcat/K(m) of thermolysin catalysis), reflecting the splitting mechanism of the SMPI inhibition of thermolysin. This Ki increased with an increase in pressure, and in (Ki-1) was almost linear with respect to pressure. The volume of the reaction (delta Vcomp), which is the volume change accompanying enzyme-inhibitor complex formation, was calculated as +8.1 +/- 0.3 mL.mol-1, which has a sign opposite to delta Vcomp for neutral peptide inhibitors and acyl-peptide substrates. The temperature dependence of Ki-1 gave the reaction enthalpy (delta Hcomp) and reaction entropy (delta Scomp) of the complex formation as 34.6 +/- 1.4 kJ.mol-1 and 298 +/- 5 J.mol-1.K-1, respectively. These positive reaction volumes and reaction entropies were related to the electrostatic interactions and ionic strength dependence of Ki which corresponded to the key ionic interaction during complex formation. Complex formation with SMPI stabilized thermolysin against pressure perturbation as observed by the changes in the Trp fluorescence of thermolysin with increasing pressure. Thermal stability, however, was affected very little by complex formation with SMPI. Phosphoramidon, Cbz-Phe-Gly-NH2 and Cbz-Phe also positively affected the pressure-tolerance of thermolysin, in the following order: Cbz-Gly-Phe-NH2 < Cbz-Phe << phosphoramidon. The third compound exhibited stabilizing effects comparable with those of SMPI, which suggests that the interaction between SMPI and thermolysin was localized to the reactive site. (+info)
A Kazal-type trypsin inhibitor from the protochordate Ciona intestinalis.
(4/552)
A trypsin inhibitor from Ciona intestinalis, present throughout the animal, was purified by ion-exchange chromatography followed by four HPLC steps. By MS the molecular mass of the native form was determined to be 6675 Da. The N-terminal amino acid sequence was determined by protein sequencing, but appeared to be partial because the theoretical molecular mass of the protein was 1101 Da too low. Thermolysin treatment gave rise to several fragments each containing a single disulphide bridge. By sequence analysis and MS intramolecular disulphide bridges could unequivocally be assigned to connect the pairs Cys4-Cys37, Cys8-Cys30 and Cys16-Cys51. The structure of the inhibitor is homologous to Kazal-type trypsin inhibitors. The inhibitor constant, KI, for trypsin inhibition was 0.05 nM whereas chymotrypsin and elastase were not inhibited. To reveal the complete sequence the cDNA encoding the trypsin inhibitor was isolated. This cDNA of 454 bp predicts a protein of 82 amino acid residues including a 20 amino acid signal peptide. Moreover, the cDNA predicts a C-terminal extension of 11 amino acids compared to the part identified by protein sequencing. The molecular mass calculated for this predicted protein is in accordance with the measured value. This C-terminal sequence is unusual for Kazal-type trypsin inhibitors and has apparently been lost early in evolution. The high degree of conservation around the active site strongly supports the importance of the Kazal-type inhibitors. (+info)
Parvalbumin from rabbit muscle. Isolation and primary structure.
(5/552)
A parvalbumin, with its characteristic low molecular weight (approximately 12000) acidic isoelectric point (approximately 5.5), ultraviolet spectrum (maxm 259 nm) and Ca2+-binding capacity (2 mol/mol protein) has been isolated from rabbit (Oryctolagus cuniculus) muscle. Its primary structure has been determined from a study of its tryptic peptides and of overlapping peptides generated by limited tryptic digestion and by chymotryptic and thermolytic digestions of the protein. The amino acid sequence so obtained is considered in comparison with those known for other parvalbumin and for rabbit troponin C. (+info)
A three-dimensional construction of the active site (region 507-749) of human neutral endopeptidase (EC.3.4.24.11).
(6/552)
A three-dimensional model of the 507-749 region of neutral endopeptidase-24.11 (NEP; E.C.3.4.24.11) was constructed integrating the results of secondary structure predictions and sequence homologies with the bacterial endopeptidase thermolysin. Additional data were extracted from the structure of two other metalloproteases, astacin and stromelysin. The resulting model accounts for the main biological properties of NEP and has been used to describe the environment close to the zinc atom defining the catalytic site. The analysis of several thiol inhibitors, complexed in the model active site, revealed the presence of a large hydrophobic pocket at the S1' subsite level. This is supported by the nature of the constitutive amino acids. The computed energies of bound inhibitors correspond with the relative affinities of the stereoisomers of benzofused macrocycle derivatives of thiorphan. The model could be used to facilitate the design of new NEP inhibitors, as illustrated in the paper. (+info)
The compact conformation of fibronectin is determined by intramolecular ionic interactions.
(7/552)
Fibronectin exists in a compact or extended conformation, depending upon environmental pH and salt concentration. Using recombinant fragments expressed in bacteria and baculovirus, we determined the domains responsible for producing fibronectin's compact conformation. Our velocity and equilibrium sedimentation data show that FN2-14 (a protein containing FN-III domains 2 through 14) forms dimers in low salt. Experiments with smaller fragments indicates that the compact conformation is produced by binding of FN12-14 of one subunit to FN2-3 of the other subunit in the dimer. The binding is weakened at higher salt concentrations, implying an electrostatic interaction. Furthermore, segment FN7-14+A, which contains the alternatively spliced A domain between FN11 and 12, forms dimers, whereas FN7-14 without A does not. Segment FN12-14+A also forms dimers, but the isolated A domain does not. These data imply an association of domain A with FN12-14, and the presence of A may favor an open conformation by competing with FN2-3 for binding to FN12-14. (+info)
Insertion of atToc34 into the chloroplastic outer membrane is assisted by at least two proteinaceous components in the import system.
(8/552)
Toc34 is a member of the outer membrane translocon complex that mediates the initial stage of protein import into chloroplasts. Toc34, like most outer membrane proteins, is synthesized in the cytosol at its mature size without a cleavable transit peptide. The majority of outer membrane proteins do not require thermolysin-sensitive components on the chloroplastic surface or ATP for their insertion into the outer membrane. However, different results have been obtained concerning the factors required for Toc34 insertion into the outer membrane. Using an Arabidopsis homologue of pea Toc34, atToc34, we show that the insertion of atToc34 was greatly reduced by thermolysin pretreatment of chloroplasts as assayed either by protease digestion or by alkaline extraction. The insertion was also dependent on the presence of ATP or GTP. A mutant of atToc34 with the GTP-binding domain deleted still required ATP for optimal insertion, indicating that ATP was used by other protein components in the import system. The ATP-supported insertion was observed even in thermolysin-pretreated chloroplasts, suggesting that the protein component responsible for ATP-stimulated insertion is a different protein from the thermolysin-sensitive component that assists atToc34 insertion. (+info)